Skip to content
Goshen Exchange

ApicultureLesson 6 of 7

Mites, disease and swarms

Breakout About 10 min readNew to you

What you’ll learn

  • Why varroa mites are the main reason hives die, and how fast they grow
  • How to run an alcohol wash and when a count means you must act
  • What the label law means for mite products, supers and temperature
  • How to tell American foulbrood from European foulbrood, and what to do
  • How to read queen cells and keep a colony from swarming

The short version

  1. Count mites every month from spring to fall with an alcohol wash of about 300 bees. Act at about 2 mites per 100 bees (1 per 100 in early spring and just before winter).

  2. Use only EPA-registered mite products, exactly as the label says. Several can't be used with honey supers on, and several have temperature limits.

Why varroa mites matter

  • Varroa feed on the fat body tissue of adult and developing bees and reproduce only in capped brood. They prefer drone brood.

  • Mite numbers can grow about 12-fold in a season where colonies raise brood half the year, and about 800-fold where they raise brood year-round, so the warm South has it hardest.

  • Mites peak weeks after the bees do. In late summer and fall, brood shrinks, mites crowd onto the bees raised for winter, and drifting or robbing bees bring in more.

  • Mites spread deformed wing virus: bees can't use their wings and die within days. In the early-2025 commercial collapses, USDA scientists found it in every sick bee they tested.

  • Untreated colonies usually collapse in about 1–3 years. In a USDA-ARS trial, 3% of untreated standard colonies survived winter, against 62.5% of mite-resistant Pol-line colonies. Backyard beekeepers who don't manage mites lose about 51% of colonies over winter, compared with 39% for those who do.

Diagram coming soonMite growth curve
Figure 1. Mites peak weeks after the bees do; the winter bees are the ones at risk.
Sources: University of Florida IFAS Extension, Published research and 2 more

Counting mites

Alcohol or soap wash (the most accurate):

  1. Scoop about 300 bees (½ cup, lightly packed) from one to three brood-nest frames. Make sure the queen isn't on them.

  2. Cover with 70% or stronger rubbing alcohol, low-suds soapy water, or windshield washer fluid that is at least 40% alcohol.

  3. Swirl hard for at least a minute, pour through a #8 mesh to catch the mites, refill, repeat and count.

  4. Mites ÷ bees × 100 = mites per 100 bees. 6 mites in 300 bees = 2 per 100.

Sugar shake (doesn't kill the bees but is less accurate): about 2 tablespoons of powdered sugar on the ½-cup sample, shake a minute, wait 3–5 minutes, shake the sugar and mites out and repeat. Skip it in humid weather or a strong flow.

Sticky boards show trends only; confirm with a wash. Georgia's treatment level for the Southeast Piedmont is 59–187 mites on a sheet left in overnight.

When to act: sample monthly from spring buildup through fall, and every colony if you have fewer than 10. The Honey Bee Health Coalition's 2026 guide says act at 1 mite per 100 bees in early spring and just before winter, and at 2 per 100 in summer and fall. Some extension services use 3 per 100. After any treatment, test again to be sure the count dropped.

Diagram coming soonMite wash, step by step
Figure 2. An alcohol wash, step by step, with the worked example.
Sources: Honey Bee Health Coalition, Mississippi State University Extension and 3 more

Treating mites

Label rates, recorded exactly as each EPA-accepted label states them. Always follow the label on your own package, because versions change:

ProductLabel rate
Api-Bioxal, dribble35 g in 1 liter of 1:1 syrup; 5 mL per occupied bee space; no more than 50 mL per colony
Api-Bioxal, vapor4.0 g per brood box
EZ-Ox, vapor2–4 g per deep box
Apivar1 strip per 5 frames of bees (2 per brood box), 42–56 days, no more than twice a year
Formic Pro2 strips for 14 days, or 1 strip for 10 days then a second for 10 days
MAQS2 strips for 7 days, or the 21-day option
HopGuard 31 strip per 5 frames of bees, 14–30 days, up to 4 times a year
Varroxsan1 strip per 2.5 frames of bees (up to 4 per box), 42–56 days

Rotate products. Mites are widely resistant to Apistan and CheckMite+, and amitraz (Apivar) resistance is spreading: every mite tested from the 2025 commercial collapses carried a resistance mutation. Formic acid labels say mites aren't expected to become resistant to it.

Without chemicals (helpful, but none is enough on its own):

  • Drone brood removal: put a drone-comb frame or two in each colony in spring, freeze it for 24–48 hours once capped, and repeat 2–3 times. If drones emerge before you remove it, mites jump.

  • Brood break: cage the queen 1–2 weeks or make a split. It stops mite breeding and makes oxalic acid work, but caging queens in fall can hurt winter survival.

  • Screened bottom boards cut mites only about 5–14%. Close them during formic acid and Api Life Var treatments.

  • Mite-resistant stock (VSH/Pol-line, Russian) slows mite growth but still needs counting.

Diagram coming soonTreatment label matrix
Figure 3. Which EPA products allow supers, their temperature bands and whether brood matters.
Diagram coming soonOxalic acid PPE card
Figure 4. What to wear for oxalic acid, and the label line to read.
Sources: US EPA, Pollinator Protection, US EPA, Office of Pesticide Programs and 14 more

Brood diseases

  • European foulbrood: larvae look melted, shrunken or rubbery, white to yellowish-brown, sometimes twisted. They don't rope. It's a spring stress disease; strong colonies can fight it off and colonies often recover. Oxytetracycline (by veterinary order) is the only approved drug.

  • Chalkbrood: chalky white-to-gray mummies of larvae, a fungus worst in cool, damp springs. Sacbrood: a virus that rarely causes severe losses. Hygienic queens help with both.

  • Nosema: brown streaks on the hive aren't proof; a microscope or lab test is needed. Fumagillin is the only treatment ever approved, and whether it's still sold in the US is unclear.

Diagram coming soonAFB vs EFB comparison
Figure 5. Rope test and cappings for American versus European foulbrood.
Sources: U.S. Food and Drug Administration, Penn State Extension and 5 more

Hive pests and predators

  • Small hive beetles:

    • Found in nearly every state and worst in the warm Southeast.
    • Strong colonies in full sun, traps from April to September, no more comb than the bees can cover, and extracting honey within 48 hours of pulling supers keep them down.
    • Freeze stored supers at least 48 hours.
  • Wax moths:

    • They wreck stored comb and are no threat below about 40°F.
    • Freezing kills every stage. A few hours is enough for a single frame; give whole supers 48 hours.
  • Skunks: they scratch at entrances at night and eat bees; a stand at least a foot high helps.

  • Mice: see mouse guards in the lesson on seasonal hive care.

Diagram coming soonBear fence diagram
Figure 6. Wire spacing, ground rod and charger for a bear fence.
Sources: Mississippi State University Extension, Penn State Extension and 4 more

Swarms

When: just before and during the main spring flow, so start swarm checks 2–4 weeks before it.

RegionSwarm season
South Georgia, FloridaFebruary/March–May
Central North CarolinaLate February–May
MidwestApril–June
Mid-AtlanticMay–mid-June
Utah, MontanaMay–July

How it works: workers build queen cells, which are capped about 8 days after the egg. The swarm usually leaves around the time the first cell is capped, and once cells are capped it's hard to stop. About half to two-thirds of the workers leave with the old queen, usually between 10 a.m. and 2 p.m. on a sunny, calm day.

Reading queen cells:

  • Swarm cells are usually many, hanging from the bottom bars and edges of frames.

  • Supersedure or emergency cells are usually fewer, on the face of the comb near the middle.

  • Empty queen cups are normal and don't mean swarming by themselves.

Prevention:

  1. Keep drawn-comb space ahead of the bees.

  2. Equalize: move brood from strong colonies to weak ones.

  3. Split strong colonies, taking 3–5 frames of brood and bees, before the main flow.

  4. Keep young queens.

  5. Cut queen cells every 7–10 days, but only after confirming the colony has eggs or young larvae to raise a new queen.

  6. Demaree method: put the queen in the bottom box below an excluder and move open brood above it.

If a swarm lands nearby, it is "not generally defensive" and usually moves on within 24–72 hours. Call a local beekeeper or your state beekeepers' association. In Africanized areas, treat every wild colony as Africanized.

Diagram coming soonQueen cells
Figure 7. Swarm cells, supersedure cells and a normal empty cup.
Diagram coming soonSwarm timeline
Figure 8. From egg in the cup to a swarm leaving, about 8 days later.
Sources: University of Florida IFAS Extension, University of Georgia Extension and 9 more

What you'll need

ItemAboutNotes
Health supplies (mite tests and treatments)$128–195 per colony a year—
Electric bear fencecharger of 0.7 J or more, 6-ft ground rod—
Sources: University of Minnesota Extension, Maine Department of Inland Fisheries and Wildlife

Troubleshooting

What you seeLikely causeWhat to do
Spotty broodFailing queen, disease or mitesCheck for disease signs; mite wash; requeen
Sunken, greasy, pierced cappings; ropy brown larvaeAmerican foulbroodClose the hive and call your state inspector
Melted, twisted larvae that don't ropeEuropean foulbroodStrong colonies can fight it off; ask a vet about oxytetracycline
Chalky white or gray mummiesChalkbroodRequeen with hygienic stock
Bees with crumpled wingsDeformed wing virus from mitesMite wash and treat by label
Many queen cells on frame bottomsSwarm preparationSplit, add drawn comb, or Demaree
Slimy, fermenting comb, beetles everywhereSmall hive beetleStrong colonies, full sun, traps; freeze and clean comb
Webs and tunnels in stored combWax mothFreeze, then store sealed
Sources: eXtension Bee Health, Texas A&M AgriLife Extension and 5 more

Common mistakes

  1. Not counting mites, or counting once and stopping. Most beginners lose their first hive to mites.

  2. Treating with supers on using a product whose label forbids it, or in heat above the label limit.

  3. Home-brewed oxalic towels or other unregistered mixes.

  4. Adding boxes of bare foundation to stop swarming.

Sources: Randy Oliver, ScientificBeekeeping.com, Honey Bee Health Coalition and 5 more

Resources

By zone

Mite pressure, small hive beetles and swarm timing change with climate. Here are the notes on those by zone and region.

3–4
Swarm season May–July. Small hive beetles rarely survive winter outside the hive.
5–6
Swarming April–June.
7–8
Swarming from late February (NC) or May (Mid-Atlantic). Heat can rule out formic and thymol treatments in midsummer.
9–10
Brood nearly year-round, so mites grow fastest and broodless windows for oxalic acid are short. Small hive beetles are worst: extract within 48 hours, keep hives in full sun.
Northeast
March starvation; bears, so electric fence;
Southeast
small hive beetles, year-round mites, swarming from February, a mid-April prime flow, and Africanized bees in southern Florida and parts of Alabama.

Where this comes from

Every fact in this lesson was checked against 55 published sources: 52 from extension services, the USDA and research journals and 3 from experienced growers and practitioners. Each section lists its own at the bottom.

See all 55 sources
Florida Department of Agriculture and Consumer Services
North Carolina Wildlife Resources Commission
Penn State Cooperative Extension / MAAREC
University of Minnesota Extension

Summary

The whole lesson on one page. Print it or come back to it.

Key information

  • Varroa mites feed on bees and spread deformed wing virus. Untreated colonies usually collapse in about 1–3 years.
  • Count mites monthly from spring to fall with an alcohol wash of about 300 bees. Mites ÷ bees × 100 = mites per 100 bees.
  • Act at about 2 per 100 in summer and fall, and at 1 per 100 in early spring and just before winter. Test again after any treatment.
  • Use only EPA-registered mite products, exactly as the label says. Check whether supers must be off and what the temperature limits are.
  • American foulbrood has no cure and its spores last 70+ years in equipment. Call your state apiary inspector.
  • Start swarm checks 2–4 weeks before the main spring flow, and keep drawn-comb space ahead of the bees.

Step by step

  1. 1.Scoop about 300 bees (½ cup, lightly packed) from the brood nest, with the queen not among them.
  2. 2.Cover them with 70% or stronger rubbing alcohol, or low-suds soapy water.
  3. 3.Swirl hard for at least a minute and pour through a #8 mesh to catch the mites.
  4. 4.Refill, repeat and count the mites.
  5. 5.Divide mites by bees and multiply by 100: 6 mites in 300 bees is 2 per 100.

Made it to the end? I’ll keep track for you on this device.