Skip to content
Goshen Exchange

ApicultureLesson 3 of 7

Seasonal hive care

Breakout About 6 min readNew to you

What you’ll learn

  • What to feed and when: syrup, pollen patties and solid feed
  • Why never to feed store-bought honey
  • When to add a super and when to reverse the brood boxes
  • How to spot and stop robbing in a summer dearth
  • How much honey to leave, where to put it, and how to manage moisture in winter

The short version

  1. Leave enough honey for winter: about 60 lb in the South and Mid-Atlantic, 80–100 lb in the North and Mountain West, stored above the cluster.

Feeding

WhenWhat
New package or nuc1:1 syrup until comb is drawn
Spring, if under about 20 lb of honey (about 3 full deep frames)1:1 syrup; March is the peak starvation month in the North
About 6 weeks before early spring bloomPollen substitute patties (late Feb–early March in Indiana and Michigan); fall patties don't help
Summer dearth (no nectar)Light syrup inside the hive
Fall, if short of winter stores2:1 syrup, fed in big amounts so it's stored; up to 4 gallons per colony
Below about 50°FSolid feed only: fondant, sugar cake, candy board or dry sugar on newspaper
  • Mixing: 1:1 is about one 5-lb bag of sugar to 2½ quarts of hot tap water. 2:1 is two parts sugar to one part water by weight or volume; heat but don't boil.

  • Use plain white sugar. Never raw, brown, organic, molasses or powdered sugar, and don't caramelize syrup or fondant; caramelized sugar is unsafe for bees.

  • Fall deadlines: Michigan State says finish 2:1 feeding by October 1; Cornell says syrup fed after the end of September can't be counted on. Texas A&M feeds 1:1 into fall and 2:1 only in winter, and central North Carolina switches to 2:1 in late September.

  • Once you start winter fondant, keep it supplied until spring.

Diagram coming soonFeeding chart
Figure 1. A feeding year: syrup, pollen patties, light syrup in dearth, 2:1 in fall and solid feed when it is cold.
Sources: Alabama Cooperative Extension, NC State Extension and 11 more

Giving them room

  • "Oversuper in spring; undersuper in fall" (Penn State). Add the next super when the one below is ½–⅔ full and being capped, or when fresh white wax appears along the top bars. Utah State adds one when the top box has 7 full frames of capped honey.

  • Reversing: when the brood nest has moved up into the top box and the bottom is nearly empty, swap the two brood boxes. Most calendars do this once in spring when the weather has settled. Never split a brood nest across boxes in cold weather.

  • Drawn comb counts as room; bare foundation doesn't. MAAREC says don't add full supers of foundation until the flow has begun or after mid-June.

Sources: Penn State Cooperative Extension / MAAREC, Utah State University Extension and 4 more

Summer dearth, robbing and heat

Dearth (no nectar) comes in July in Pennsylvania, late July–September in eastern North Carolina, early August in the Midwest, August–September in Michigan, and after the main flow ends in June–July in Florida.

Robbing (strong colonies stealing from weak ones) is the danger in a dearth.

  • Signs: heavy traffic at the entrance, bees trying to get in through cracks, robbers swaying back and forth as they approach, fighting and dead bees on the ground.

  • Prevent it:

    • keep inspections short and combs covered;
    • shrink entrances to fit colony strength;
    • feed only inside the hive, in the evening;
    • never spill syrup or leave comb out;
    • tape gaps, and use robbing screens.

Desert heat:

  • The brood nest must stay about 93–95°F, and Arizona summers run hotter.

  • Afternoon shade cools a hive by 10–15°F, and fine mist about 10°F more.

  • Vent through the top with a Vivaldi board or screened inner cover.

  • Strap hives together and keep them off low ground before monsoon winds and floods.

Bearding (bees clustered on the front on hot evenings) is normal. A screened bottom board or a cover propped about ¼ in helps.

Sources: Penn State Extension, NC State Extension and 9 more

Winter honey to leave

AreaHoney
North Carolina, Alabama, Mid-AtlanticAbout 60 lb (Penn State: about 125 lb total for two deeps)
GeorgiaAt least 100 lb total hive weight
Montana60–90 lb used over winter
Michigan70–100 lb
Minnesota75–95 lb in three deeps
Colorado, Utah80–100 lb
New York (Cornell)At least 80 lb; nucs at least 50 lb
Pacific Northwest nucsAbout 45 lb

Put the honey above the cluster. The cluster moves up through its stores and won't move down to honey below it, even when starving. Penn State wants at least 40–45 lb in the top box.

Heft each hive: lift the back and learn how a full hive feels in fall. Lift again in late winter (February in the South, March in the North) and give solid sugar to light ones.

Diagram coming soonWinter stores map
Figure 3. How much honey to leave, from the South to the Mountain West.
Sources: NC State Extension, Alabama Cooperative Extension and 10 more

Fall checklist

  1. Strong colony: a young laying queen, plenty of bees (Minnesota: 10+ frames of bees; Washington State: 8+), solid brood and low mite counts.

  2. Combine weak colonies into strong ones with the newspaper method, keeping the better queen.

  3. Mouse guards in early to mid fall: an entrance opening about 3/8 in high, or hardware cloth with 3 squares per inch. Purdue notes ½-in cloth lets some small mice through. Remove guards in spring.

  4. Moisture control: moisture, not cold, is the main danger inside the hive. The bees' breath condenses under a cold lid and drips on them. Insulate the top (foam board, or a porous moisture board in the far north) and give an upper vent.

  5. Upper entrance: Penn State says upper and lower entrances together "can increase winter survival." A top entrance (about a 5/8-in hole or a shim under the inner cover) lets out moisture and gives an exit if snow or dead bees block the bottom.

  6. Tilt the hive slightly forward (back a little higher) so water runs out.

  7. Wrap sides only in the far north (zones 3–5) or exposed, high sites: Minnesota wraps after November 1 over a moisture board with a top entrance. In milder climates heavy wrapping can trap moisture.

In winter: bees cluster below about 57°F and make heat by shivering their flight muscles, burning honey as fuel. Check that a colony is alive by knocking on the hive and listening for a buzz, and keep snow off the entrance.

Diagram coming soonWinter hive cross-section
Figure 2. A winter hive: cluster low, honey above it, insulation, an upper entrance and a mouse guard.
Sources: University of Minnesota Bee Lab, Washington State University Extension and 8 more

Why colonies die over winter

Going in small or weak, starvation, varroa mites and the viruses they spread, disease, moisture and bad weather. Washington State says most losses trace to management mistakes. Bees head-first in cells with no honey nearby means starvation; mold and water stains mean moisture. Clean up dead hives early in spring so robbers don't spread disease.

Sources: Washington State University Extension

Troubleshooting

What you seeLikely causeWhat to do
Fighting and dead bees at the entranceRobbingShrink the entrance, robbing screen, stop open feeding
Bees clustered on the hive front in heatBearding (normal)Ventilate
Dead colony, bees head-first in cells, no honey nearbyStarvationLeave more honey above the cluster; heft in late winter
Dead colony, moldy, water stains under the lidMoistureTop insulation and upper vent
Sources: University of Arizona Extension, Penn State Cooperative Extension / MAAREC and 3 more

Common mistakes

  1. Taking too much honey or leaving it below the cluster.

  2. Feeding syrup too late in fall, or syrup in freezing weather instead of solid feed.

  3. Long inspections in a dearth, spilled syrup, or entrance feeders, which start robbing.

  4. Feeding store honey to bees.

  5. Wrapping hives tight in a mild climate, which traps moisture.

Sources: Penn State Cooperative Extension / MAAREC, Michigan State University Extension and 3 more

Resources

By zone

Cold, heat and dearth set the feeding and winter calendar. Here are the notes on honey to leave, feeding and winter setup by zone and region.

3–4
Leave 75–100 lb of honey. Wrap sides after November 1 over a moisture board with a top entrance. Finish 2:1 syrup by about October 1; fondant from January to March.
5–6
Leave 70–100 lb. Top insulation and an upper vent; wrap only exposed sites. March is the starvation month. Pollen patties in late February.
7–8
About 60 lb of honey. July–September dearth and robbing. 2:1 syrup in late September–October.
9–10
About 60 lb, or 100 lb total hive weight in Georgia. Desert hives need afternoon shade, top vents and water.
Midwest
hard winters; pollen patties 6 weeks before maple bloom;
Pacific Northwest
wet winters, so insulated tops and upper vents; blackberry flow around June 20; overwintered nucs made by May 20–July 20;
Mountain West
80–100 lb of stores; wrap and strap hives at elevation; no state program in Colorado.

Where this comes from

Every fact in this lesson was checked against 24 published sources: 23 from extension services, the USDA and research journals and 1 from experienced growers and practitioners. Each section lists its own at the bottom.

See all 24 sources
Colorado State University Extension
Michigan State University Extension
Penn State Cooperative Extension / MAAREC
University of Florida IFAS Extension

Summary

The whole lesson on one page. Print it or come back to it.

Key information

  • Feed 1:1 syrup to a new package or nuc until the comb is drawn. Below about 50°F, switch to solid feed: fondant, sugar cake, candy board or dry sugar on newspaper.
  • Use plain white sugar only. Never feed store-bought honey: it can carry American foulbrood spores.
  • Add the next super when the one below is ½–⅔ full and being capped. Drawn comb counts as room; bare foundation doesn't.
  • Leave enough honey for winter: about 60 lb in the South and Mid-Atlantic, 80–100 lb in the North and Mountain West, stored above the cluster.
  • Moisture, not cold, is the main danger in winter. Insulate the top, give an upper vent, and wrap the sides only in the far north or exposed sites.
  • Fit mouse guards in early to mid fall, with an opening about 3/8 in high.

Step by step

  1. 1.Make sure the colony is strong: a young laying queen, plenty of bees, solid brood and low mite counts.
  2. 2.Combine weak colonies into strong ones with the newspaper method, keeping the better queen.
  3. 3.Check that honey sits above the cluster, and heft each hive to learn how a full hive feels.
  4. 4.Fit mouse guards in early to mid fall.
  5. 5.Insulate the top, add an upper vent and tilt the hive slightly forward so water runs out.

Made it to the end? I’ll keep track for you on this device.