Skip to content
Goshen Exchange

WaterLesson 5 of 7

Filtration and purification

Breakout About 8 min readNew to you

What you’ll learn

  • Why a private well is your responsibility, and how and when to test it
  • What EPA's public-water limits mean as benchmarks for a well
  • What each treatment device does and doesn't remove
  • How to make water safe in an emergency and how much to store
  • How to protect babies, livestock and plumbing from nitrate, lead, salts and germs

The short version

  1. Test a private well every year for total coliform, nitrate, TDS and pH at a state-certified lab, and again after floods, repairs or a change in taste or smell.

  2. Never boil water to remove nitrate. Boiling concentrates it. Use bottled water for babies under 6 months and treat only with reverse osmosis, ion exchange or distillation.

Your well isn't regulated

Schedules differ: North Carolina tests nitrate every 2 years, Oregon State says 1–3 years; for arsenic Minnesota says once, Wisconsin every 5 years, Washington twice (summer and winter), New Mexico yearly. Use the yearly four plus your region's list.

Diagram coming soonTest calendar
Figure 1. The yearly four tests and the events that call for a test.
Diagram coming soonSampling steps
Figure 2. Collecting a bacteria sample.
Sources: CDC, U.S. Environmental Protection Agency and 8 more

Standards (EPA, checked 2026-10-04)

ContaminantEPA public-water limitNotes
Nitrate10 mg/L as nitrogenBabies under 6 months at risk
Nitrite1 mg/L as nitrogen—
Arsenic0.010 mg/L (10 ppb)Can't be tasted or smelled
Fluoride4.0 mg/L (2.0 secondary)—
Uranium30 µg/L—
LeadAction level 0.015 mg/L, falling to 0.010 mg/L on Nov 1, 2027; health goal zeroUtility trigger, not a household limit
PFOA, PFOS4.0 parts per trillion (2024); rule under revisionSee below

These limits apply to public systems, not private wells; use them as benchmarks. PFAS: on May 18, 2026 EPA proposed to keep PFOA and PFOS limits (compliance 2029, or 2031 on request) and rescind the other 2024 PFAS limits; nothing is rescinded yet. Recheck before relying on this.

Diagram coming soonNitrate and babies card
Figure 4. Boiling concentrates nitrate.
Sources: U.S. Environmental Protection Agency, Minnesota Department of Health and 4 more

What to test for where you live

RegionAlso test for
NortheastArsenic, radon, uranium, manganese, lead
SoutheastManganese, arsenic (coastal plain), lead, iron, low pH
MidwestNitrate, arsenic, manganese, sulfate for livestock
SouthwestArsenic, fluoride, uranium, TDS
Pacific NorthwestArsenic (summer and winter), nitrate
Mountain WestUranium, radon, arsenic, nitrate, fluoride, PFAS

USGS found arsenic above 10 µg/L in about 16% of sampled Southwest wells; about 10% of Minnesota private wells exceed it. Maine advises bottled water for drinks and formula at uranium of 30 µg/L or more, and no cooking of rice, beans or pasta in it above 130 µg/L. EPA has no enforceable radon limit for water, and recommends testing wells.

Sources: U.S. Geological Survey, Minnesota Department of Health and 2 more

Treatment: what each device does and doesn't do

ContaminantWhat worksWhat doesn't
Bacteria and virusesDistillation, UV (clear water), continuous chlorinationCarbon, softeners, sediment filters alone
NitrateRO, anion exchange, distillationCarbon, boiling, softeners
ArsenicAdsorptive media, anion exchange, RO, distillation (check the arsenic form)Carbon, softeners
LeadCertified carbon, RO, distillationBoiling
FluorideRO, adsorptive media, anion exchange, distillationCarbon
RadonAeration or carbon at the point of entryPoint-of-use alone
PFASCarbon, RO, ion exchange (NSF 53/58)Filters aren't yet certified to the 4 ppt level
Iron, manganese, sulfideAeration, oxidizing filters, chlorination plus filtrationCarbon alone for heavy loads

The two best matrices (Maine and Minnesota) differ in places; check each product's certification.

Don't rely on a vendor's in-home test. Use a state-certified lab and get several quotes.

Diagram coming soonTreatment-vs-contaminant grid
Figure 3. What works and what doesn't for each contaminant.
Sources: CDC, Ohio Department of Health, Bureau of Environmental Health and 5 more

Emergency water

Diagram coming soonEmergency water
Figure 5. Boil, bleach and store water for an emergency.
Sources: U.S. Environmental Protection Agency, CDC

Germs in your plumbing and your well

Sources: CDC

Lead

Diagram coming soonLead precautions
Figure 6. Lead precautions at the tap.
Sources: U.S. Environmental Protection Agency

Livestock water

  • TDS: under 3,000 mg/L is usually satisfactory for livestock (NDSU); 3,000–5,000 can loosen stools in young animals; near 5,000 is unacceptable for poultry. Penn State and Missouri use stricter lines.

  • Sulfate: under 500 ppm for calves, under 1,000 for adult cattle.

  • Nitrate: check the units. Missouri states nitrate-nitrogen (under 100 ppm shouldn't harm livestock) and 1 ppm nitrate-N equals 4.4 ppm nitrate; NDSU lists 100 ppm nitrate with no stated basis.

  • Test shallow wells and ponds, especially in drought and spring runoff. Use a TDS meter and sulfate test strips; send a lab sample if TDS tops 4,500 ppm or sulfate 800 ppm.

  • Hot, dry weather: blue-green algae in stagnant tanks and ponds can kill. Fence livestock out of ponds and pipe water to a trough.

Sources: NDSU Extension, Penn State Extension and 1 more

Costs (dated)

  • Tests: bacteria about $20–$40 (Penn State 2025), $27–$42 at the Maine state lab (2026); lead $20–$100.

  • Treatment (Minnesota 2017–18 estimates): point-of-use carbon $10–$100, RO $300–$1,500, distillation $300–$1,200, UV $150–$300; whole-house carbon $500–$3,000; whole-house RO $5,000–$12,000. Texas A&M (2020): RO $300–$1,000. EPA (2024): pitchers under $100, RO and distillation a few hundred dollars.

Sources: Penn State Extension, Maine Health and Environmental Testing Laboratory and 4 more

Materials and costs

ItemAboutNotes
Bacteria test$20–$42—
RO unit$300–$1,500—
UV unit, point-of-use$150–$3002017–18
Sources: Penn State Extension, Maine Health and Environmental Testing Laboratory and 2 more

Common mistakes

  1. Boiling water to remove nitrate.

  2. Never testing a private well, or testing only once.

  3. Relying on a carbon pitcher to make well water safe.

  4. Skipping the lead precautions for formula.

Sources: Minnesota Department of Health, CDC and 1 more

Troubleshooting

What you seeLikely causeWhat to do
Well water tastes salty or looks cloudyHigh TDS or sedimentTest; ask the health department
Sources: CDC

Resources

By zone

What your water is likely to contain depends on where you live. Here is what to test for by zone and region.

3–4
Test for arsenic and radon in rock wells.
5–6
Nitrate in farm areas.
7–8
Manganese and arsenic in the coastal plain.
9–10
Arsenic, fluoride, uranium and TDS to test for.

Where this comes from

Every fact in this lesson was checked against 42 published sources, all from extension services, the USDA and research journals. Each section lists its own at the bottom.

See all 42 sources
Colorado State University Extension
Ohio Department of Health, Bureau of Environmental Health
Oregon State University Extension
U.S. Environmental Protection Agency, WaterSense program
Wisconsin Department of Natural Resources

Summary

The whole lesson on one page. Print it or come back to it.

Key information

  • EPA's drinking-water rules don't apply to private wells, so the owner is responsible. Test every year for total coliform, nitrate, TDS and pH at a state-certified lab.
  • Never boil water to remove nitrate: boiling concentrates it. Use bottled water for babies under 6 months, and treat only with reverse osmosis, ion exchange or distillation.
  • Carbon filters don't remove germs, nitrate, or minerals and salts like arsenic. Only certification for your specific contaminant counts.
  • For emergency water, bring clear water to a rolling boil for 1 minute, and for 3 minutes at high elevation. Boiling won't remove heavy metals, salts, fuel or most other chemicals.
  • Store at least 1 gallon per person per day for 3 days (2 weeks if you can), in food-grade containers, replaced every 6 months.
  • Use cold water only for drinking, cooking and formula, because boiling doesn't remove lead.

Step by step

  1. 1.Test your well at a state-certified lab for the yearly four, plus your region's list.
  2. 2.Compare results with EPA's public-water limits as benchmarks.
  3. 3.Choose a treatment certified for your specific contaminant, such as NSF/ANSI 53, 58, 55 or 62.
  4. 4.Maintain it: for example, replace a UV lamp yearly.
  5. 5.Store emergency water: at least 1 gallon per person per day for 3 days.

Made it to the end? I’ll keep track for you on this device.